Override Park Low Profile Hand Brake.
Override park low profile hand brake is used when conventional park brake assemblies are too high.
- Hole Spacings 184mm x 54mm x 13.5mm
- Low Profile – 140mm from the top of the plate to the bottom of the handle.
Mount the brake plate under the override coupling. The holes should line up correctly so that the push plate is directly over the push assembly on the rear of the Override coupling.
Mount your adjustable cable connector onto the lower arm bolt position and connect the cable to your brakes. Adjust the cable enough to remove the slack from the park brake cable.
Note: This adjuster does not adjust your brakes, it removes the slack from your cable. There is another procedure to adjust your brakes.
Also fits the following couplings.