Hydraulic Master Cylinder Park Brake – 610949

SKU: 610949 Category:


13 in stock

13 in stock

Couplemate accepts PayPal, Visa and Mastercard.

Hydraulic Master Cylinder Park Brake – Zinc

Hydraulic master cylinder park brake fits 7/8-inch, 3/4-inch and 1-inch hydraulic master cylinders.

This zinc bracket is also a parking brake for hydraulic braking systems.

  1. Fit the master cylinder bracket on the rear bolt mounts
  2. Bolt hole mounts are 54mm between centres
  3. Select 1/2-inch bolts that bolt right through your bracket, coupling and drawbar
  4. Disconnect the parking brake
  5. Adjust the lower nut 2mm from the back of the override, then lock it off.

Further, we have more information from our engineer

  • you must have at least 2mm free play, between 2mm and 5mm, when the hydraulic brake pads start to wear
  • if there is no free play, as soon as the brakes start to work and get a little warm, you will start to get brake build-up, increasing heat and burning out your brakes or even popping the seals in the master cylinder

Also suitable for use with Hydrastar brake controllers. Use as park brake only with the correct master cylinder.

hydraulic override bracket

It is also known as 610943 when used in conjunction with a master cylinder.

Purchase Master Cylinders here

Additional information

Weight2 kg
Dimensions20 × 10 × 10 cm


    Be the first to review “Hydraulic Master Cylinder Park Brake – 610949”

    Your email address will not be published. Required fields are marked *