Hydrastar – 1200 psi Brake Actuator to suit Boat Trailers UNDER 3.2t
Hydrastar – 1200 psi brake actuator generation 7 suits boat trailers under 3.2t. The Hydrastar® actuator requires a 12 volt DC Tekonsha iPrimus or P2 hard-wired controller. Redarc brands are also suitable.
Why do I need this type of brake controller?
The Law requires trailers over 2t to install a breakaway kit on your trailer or caravan.
Couplemate has good stocks of this product and ships from Brisbane.
Carlisle offers a 2-year warranty on all HydraStar® 1200 psi units against faulty workmanship. Warranty issues are handled here in Australia.
1200 psi Hydrastar Specifications?
- Application: single, or tandem-axle trailers with disc brakes
- Maximum output pressure: 1,200 psi
- Power: 12V DC
- Hydraulic port size: 3/16″
- Dimensions: 11-3/4″ long x 3″ wide x 7-3/8″ tall
- Wire configuration:
- Black: 12-volt power
- Blue: brake controller
- Yellow: breakaway
- White: ground
- 2-Year limited warranty
Trailer braking is the most critical function of towing. Therefore, electric braking provides the ultimate in control and safety
HydraStar® claim to have the quickest response time and the lowest current draw of any brake actuator on the market.
Note: Proportional controllers do not supply 100% of the voltage when the vehicle is not moving. Your car must be driving for the Hydrastar® to work correctly.
To test the braking system, pull the pin on the breakaway kit to assist you to bleed the system of hydraulic oil.
Hydrastar® equipment is available for
- 1200 psi is suitable for boat trailers up to 3.2 Tonne.
- Trailers over 3.2t require the 1600 psi model
What is a Breakaway Kit
A breakaway kit applies brakes for not less than 15 minutes in the event the trailer disconnects from the tow vehicle.
Note the CM702 breakaway kit is not supplied but required if your boat and trailer is over 2t.
Purchase a breakaway kit by clicking the image.
We try our best to get your purchase into the transport systems like Australia Post and Toll Ipec as quickly as possible.
Purchase Hydrastar – 1200 psi replacement trailer parts here
- Hydrastar® Circuit Board
- Hydrastar® Gasket
- Replacement Cap
- Brass Hose Connectors
- Hydrastar Mounting Bracket
Couplemate recommends the use of stainless braided SAE hydraulic hose. Bundy tube or steel tube can become damaged and as a result, restricts the flow of brake fluid.
Braided hose is flexible and poly-coated for long life. Copper tube olive ends with short brass locking nuts. The braided tube is designed to fit fittings with inbuilt olive connectors.
Equipment like Alko and Trojan caliper requires an olive adaptor nut with copper washer to properly seal hydraulic connections.
Finally, stainless braided hydraulic hose is a good investment to use to connect your Hydrastar to the hydraulic calipers.
Please leave a comment if you like our prices and prices.
Couplemate Trailer Parts sells only the best quality Hydrastar – 1200 psi and caravan spare parts throughout Australia.
Customers are welcome to either pickup or take advantage of our low freight rates. Express shipping to Melbourne, Sydney, Brisbane, Perth, Adelaide, Darwin, and Hobart.
We also ship products to New Zealand via Australia Post Air Express.
© Steve Wotherspoon April 24, 2015. Images and text may be copied, provided a link back to the copied page and the source is displayed where the content or image is located.