Last updated on January 11th, 2020 at 12:25 pm
Hydrastar Gasket to suit 1200psi and 1600psi Hydrastar models
Hydrastar Gasket to suit 1200psi and 1600psi Hydrastar Electric controllers. Accidents happen and there is a replacement gasket is available.
Beware of perished gaskets.
Old gaskets can be almost impossible to remove. You are actually quite fortunate if you can remove your gasket intact.
When replacing your circuit board it is a good idea to replace the gasket also.
This gasket suits the new Australian version Gen 7 hydrastar and also fits all previous hydrastar versions and fits
DIY install. Make a drawing of the terminals and where they are located. Remove spade terminals, remove the circuit board from the housing.
Install wires onto the new circuit board and reinsert into housing.
Please ensure all of your gaskets are clean before applying gasket seal and reseal housing onto the body.