Al-ko IQ7 Xtreme Electronic Control Unit

Description

Al-ko IQ7 Xtreme Electronic Control Unit

Al-ko IQ7 Xtreme Electronic model fits Extreme control units only.

Find further actuator in-car installation information from Al-ko here.

Al-ko IQ7 Xtreme Controller

Initilisation Sequence

The object of the initialisation sequence is to establish minimum and maximum braking pressure limits based on the towing vehicles braking characteristics.

This sequence need only be undertaken during initial installation, however, should braking characteristics require modification the sequence can be repeated.

Step 1:

Set the Mouse gain to the minimum position (i.e. far left) and start the vehicle with the panic button pressed down (simultaneously). DO NOT have your foot on the brake pedal when starting the vehicle. Two short beeps and two flashes from the mouse indicates you are in calibration mode.

Step 2:

Place light pedal pressure on the brake pedal at the point that you require maximum trailer braking and press the panic button. Three beeps and three flashes indicate that the maximum brake pressure calibration has occurred correctly.

Note1: If the maximum brake pressure calibration is set too high, insufficient trailer braking will occur. Repeat the initialisation sequence. At Step 2 place a lighter brake pedal pressure.

Note2: All steps have ‘sensible limit’ checks and will revert to default values if expected values are not found.

Purchase Al-ko Extreme Product below

• Al-ko Xtreme Electric/Hydraulic brake controllers
• Al-ko IQ7 Xtreme Electronic Control Unit

Couplemate Trailer Parts sells only the best quality Al-ko IQ7 Xtreme Electronic Control Unit and caravan spare parts throughout Australia.

Customers are welcome to either pickup or take advantage of our low freight rates. Express shipping to Melbourne, Sydney, Brisbane, Perth, Adelaide, Darwin, and Hobart.

We also ship products to New Zealand via Australia Post Air Express.

© Steve Wotherspoon June 10, 2019. Images and text may be copied, provided a link back to the copied page and the source is displayed where the content or image is located.