Last updated on October 4th, 2019 at 02:41 pm
XL ElectraStar circuit board electronics are not submersible so do not get them wet under any circumstances.
Manufacturers make every effort to encapsulate circuit boards in water-resistant resin to waterproof electronics.
However, accidents happen and there is a replacement circuit board available. ElectrsStar circuit boards are not repairable once submerged or water damaged.
Replace American circuit boards with this Australian controller.
American circuit boards are not comparable with Australian brake controllers. However, it is possible to replace a broken or water damaged American circuit board with this Australian model.
Do it Yourself install.
- Locate and note terminal markings.
- Remove spade terminals.
- Remove the circuit board from the housing.
- Install wires onto the new circuit board.
- Reinsert into housing.
Furthermore, please ensure all of your gaskets are clean before applying a gasket seal and reseal the housing onto the body.
Finally, bleed your brake lines to ensure there are no air bubbles in the hydraulic lines.