Holden Trailer Rescue Spare Wheel Kit suits LM Bearing and is galvanised for boat trailers. All parts for this spare wheel carrier are galvanised and made in Australia.
Install the spare wheel holder on the draw bar near the winch post. Grease the disc or hub assembly for emergency replacement in the case of a flat tyre or damaged hub or disc rotor.
- Inner ID 31.75mm, OD 59.10mm.
- Outer ID 19.05mm, OD 45.20mm.
- Seal ID 37.5mm, OD 59.10mm.
- Dust Cap 45.20mm.
Trailer Rescue Spare Wheel Kit contains
- Two galvanised u-bolts plus galvanised nylocks and galvanised washers.
- 50mm x 50mm galvanised vertical holder.
- 1 x backing plate suits 75mm and 100mm drawbars.
- 1 x 39mm Round Galvanised axle includes castellate nut and split pin.
- Castellated nut, spring washer and R clip to retain axle inside 50mm square tube.
- Select the correct stud pattern for a complete galvanised hub.
- LM Bearings.
Our Brisbane factory machines trailer rescue kit, hubs and studs the castings. Our castings are manufactured in Sydney.