Rocker Roller 60mm Steel Bush

Description

Rocker Roller 60mm Steel Bush suits Rocker Roller springs

Rocker roller 60mm steel bush is an essential replacement where the usage has worn the ID or the OD has reduced in size enabling the spring to jump on the roller.

The bush must be 59mm wide with an ID of 16mm. (known as a 60mm bush).

60mm rocker roller spring made by Al-ko and other manufacturers all use a 60mm bush.

We no longer sell plastic rocker roller bushes due to load failure in many cases. Use this bush to replace plastic 60mm roller bushes.

The metal bush carries loads up to 1125kg for 4.5t suspension systems.

Specifications

1. ID: 16mm
2. OD: 35mm
3. Length: 59mm

When installed correctly this 60mm bush must roll freely between the front and back of the rocker spring eyelet.

Some installers like to install hangers on a piece of angle iron (see photo below).

How to install rocker roller springs

1. Layout a piece of angle iron
2. Tack weld the centre bracket into position.
3. Bolt the rocker roller complete set into the centre bracket.
4. Stretch the front spring as far as possible and clamp, then tack weld.
5. Repeat for the rear spring.

Note: There is a problem if your rocker roller spring looks different from the above image.

Purchase associated trailer parts are

• 45mm Spring Bushes
• Rocker Roller 60m Bush
• 18mm x 100mm HT Rocker Roller Center Bolt
• 19mm x 75mm HT Rocker Roller Center Bolt

Couplemate Trailer Parts sells only the best quality Rocker Roller 60mm Steel Bush and caravan spare parts throughout Australia.

Customers are welcome to either pickup or take advantage of our low freight rates. Express shipping to Melbourne, Sydney, Brisbane, Perth, Adelaide, Darwin, and Hobart.

We also ship products to New Zealand via Australia Post Air Express.

© Steve Wotherspoon March 29, 2016. Images and text may be copied, provided a link back to the copied page and the source is displayed where the content or image is located.