10t x 3″ Tow Ball suit 10t Gooseneck.
10t x 3″ Tow Ball. 2 inch Shank Dia suits 40mm thick plate. Rated to 10,000kg.
- ADR Approved.
- CRN 47277.
- D-Value 58kN
- V-Value 40kN
10t x 3 tow ball suit 10t Gooseneck or Fifth Wheel Couplings. 3″ Tow Ball Tested in Australia to ADR62/2.
This ball can be used in a 40mm tow bar mount position.
Please note: Discounts are available from our online shop only, from time to time.
To comply with Australian standards, 3″ Tow Ball must be
- stamped with the ball size
- ball capacity
- manufacturers name.
Furthermore, 3″ Tow Balls must comply with Australian standards and ADR 62/2.
The torque setting for the CM298 Tow Ball – 1 3/4” x 12 TPI UNF thread – SAE 1045 material, is 2297 lbs. Ft (3114 NM) for Non-Lubricated. Lbs.Ft to NM x 1.356
Changes to ADR Tow Balls.
ADR tested tow balls cannot be changed due to the high compliance cost. Any changes to the tow ball cause the tow ball to be retested.
It is wise to purchase your tow ball and then design your gooseneck setup.
The gooseneck coupling that suits this ball is the CM520.
The dealer arranges for the installation, considering the intended application and the customer’s preference.
Coupling installers need to consider the strength of the towbar or bed plate and the rating and certification of the coupling before installation. Towball collars are available to strengthen the bed plate.
When you purchase from Couplemate Trailer Parts, your CRN identification number for this product is located on your Invoice. The CRN on the approval letter will be the same CRN on your Invoice.
Show vehicle inspectors this invoice during inspections of your trailer or vehicle if required.
Furthermore, if you are buying a similar product without a CRN and your trailer or vehicle is older than July 2009, therefore, it is not legal to use on Australian roads.