Trailer Chassis Parts

Showing all 6 results

  • Spring Holder - Horse Float Tail Gate

    Spring Holder – Horse Float Tail Gate

    $69.50 inc GST
    Add to cart
  • tailgate spring

    Tailgate Ramp Loader Spring

    $122.50$218.90 inc GST
    Select options
  • denso tape

    Denso Tape – 50mm x 10mtr

    $19.50 inc GST
    Add to cart
  • rubber wheel chock

    Rubber Wheel Chock – Trailer Stabilisation

    $16.35 inc GST
    Add to cart
  • Endcap Plastic Inserts

    Endcap Plastic Inserts 50mm – 100mm

    $3.50$7.10 inc GST
    Select options
  • vin plate sml

    VIN Plates for Trailers

    $15.00$18.50 inc GST
    Select options

Jerry Cans, Gas Bottles and trailer chassis accessories.

Weld these trailer coupling plates to the top of your chassis rails, so you can bolt the coupling onto them.

At Couplemate, we stock over 1500 trailer spares to suit most trailer and caravans.

Buying and cutting flat steel can be expensive and time-consuming, When manufacturers cut plates to size and pre-drill holes in the correct position for your coupling, you save quite a bit. This is a practical solution for what would otherwise be a difficult job.

Coupling plates are generally 6mm; with chassis rails so close to each other, you simply won’t need thicker material.

Manufacturers pre-drill shackle plates as follows (no, we do not pre-drill these plates to different hole configurations).

  • 100mm for two-hole plates
  • 184mm x 52mm for 4-hole plates.

You weld coupling plates on top of the chassis rails, or under them. When you weld these under the chassis rails, they go between the chassis rails. This provides a lower attachment point for the trailer or caravan.