45mm Square Galvanised U-Bolt

$9.00$12.00

SKU: U45SGH Categories: , Tags: , , ,
Couplemate accepts PayPal, Visa and Mastercard.

45mm Square Galvanised U-Bolts

45mm Square Galvanised U-Bolt 45mm Square incl galvanised nylocks and washers. Available lengths are 100mm | 112mm | 125mm | 137mm | 150mm | 162mm | 175mm

Rolled threads with gal flat washer + gal nylock. The thread length is 60mm.

Some of the longer u-bolt lengths are difficult to locate. Couplemate carries a good stock of these longer u-bolts because we know you want them in a hurry. You have the choice at checkout to send via Express Post if you wish.

How do I calculate the correct length?

  • Spring width plus
  • Axle Pad 8mm plus
  • Axle width plus
  • Nylock plus

How to Measure U-bolts (example right image)

Why should I check and re-tighten u-bolts?

Firstly, you must retighten U-bolts approx 200kms after installation due to steels ability to stretch a little under load.

U-Bolts generally fail due to hydrogen embrittlement. Hydrogen embrittlement occurs during bending and galvanising. At Couplemate we have a new process that removes hydrogen embrittlement to produce ST class U-bolts.

We stress-tested these u-bolts during manufacture and batch test until destruction.

What is the rating for u-bolts?

Destruction loads exceed 17,000kg for 1/2 inch galvanised u-bolts.

Our U-bolts are derated to 375kg each or 1500kg per set of 4 or enough U-bolts to suit a single axle.

The max rating of 60mm Round axles is 3000kg with a u-bolt rating of 1500kg.

Read why u-bolts could be the primary cause of accidents.

This article is the catastrophic result of the incorrect tightening of the u-bolt on a truck chassis.

Purchase from our full list of U-bolts

Galvanised U-Bolt 45mm Square Clamp Kits are listed below

Additional information

Weight0.5 kg
Dimensions10 × 6 × 2 cm
Select U-Bolt Length

100mm, 112mm, 125mm, 137mm, 150mm, 162mm, 175mm

Reviews

    Be the first to review “45mm Square Galvanised U-Bolt”

    Your email address will not be published. Required fields are marked *