9 inch Mechanical Backing Plate – Right
$49.75
Shipping
9-inch Mechanical Brake Plate – Right Side
9-inch right hand mechanical brake plate is cable actuated at the brake lever causing two identical shoes to apply a braking force into a cast-iron brake drum.
Brake shoes and brake discs are known as friction brakes. Vehicle brakes are also friction brakes; however, these braking systems may be hydraulic or electric brakes.
Installation of the Brake Shoes
However, please pay attention to the shoe offset below when installing into a drum.
Locate the handbrake on the bottom of the axle. This is opposite to electric brake installation.
13 inch to 14-inch wheels 1450kg. 15 inch to 16-inch wheels is 1200kg
Brake Shoes
9-inch x 45mm. Maximum cable tension during braking is 165kg. Hole spacings are 76.15mm P.C.D.
Occasionally, it is better to replace the whole backing plate as other components may be showing wear. A four-hole post mount fixes mechanical braking plates welded to the axle, behind the rear grease seal.
The job becomes more manageable, removing a few bolts then replacing the whole backing plate. Entire backing plates are relatively inexpensive.
How to replace 9 inch Brake Shoes
- Take off the wheel, remove the grease cap and split pin and take off the drum.
- Remove the worn brake shoes.
- Keep the springs in a container ready for re-insertion.
- Check that there is grease on the backing plate under the lever assembly (at the bottom), use molybdenum grease as required.
- Assemble the new backing plate shoes with the springs between the shoes, as shown in the image above.
- The longer spring must be assembled in the lower position, the shorter spring in the top place. Note that left-hand side brakes are a mirror image to right-hand side brakes.
Fit the drum over the brake shoes and reassemble.
Why do my trailer brakes fade?
- Dirt, oil or grease on the brake shoes – clean
- Worn brakes shoes – replace
- Badly adjust brake shoes – adjust
- Trailer overloaded causing brakes to overheat – reduce trailer weight or upgrade trailer.
Mechanical Braked Axles
- 45mm Round Mechanical Drum Brake Kit – 1450kg
- 45mm Square Mechanical Drum Brake Kit
- 40mm Square Mechanical Drum Brake Kit – 1000kg
- 40mm Square Hydraulic Drum Brake Kit – 1000kg
Find more 9-inch hydraulic parts here.
- 9-inch Hydraulic Wheel Cylinder
- 9 inch Hydraulic Brake Shoes
- 9-inch Mechanical Backing Plate – Right
- 9 inch Mechanical Backing Plate – Left
- 9-inch AL-KO Brake Drum, including Studs
Additional information
| Weight | 3 kg |
|---|---|
| Dimensions | 30 × 30 × 10 cm |
| Brake Type | Mechanical |
Our Service Lifetime Warranty
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Couplemate™ is a manufacturer and vendor of high-quality towing, trailer, and caravan components. Couplemate™ Core Goods and Custom Work are guaranteed to be free of defects for the service lifetime of the product when used as intended.
Warranties are non-transferrable and Couplemate™ requires satisfactory proof of purchase prior to issuing a remedy. The full Couplemate™ Warranty Policy can be found in the Terms & Conditions: Section 8 – Consumer Guarantees & Warranty.
Warranties are in addition to your rights under the Australian Consumer Law. If something is wrong with your order, please contact our team.
60-Day Returns
After 60 years of experience, we know that life has its unpredictable moments.
All Couplemate™ orders (online, over the phone, or in-store) have a 60 day period for change-of-mind returns and exchanges. There are some items that can’t be returned and some returns may incur a 15% restocking fee.
You can view our full policy for change-of-mind returns here.
Related products
-
12-inch Off-Road Dexter Style Electric Backing Plate – Right
$175.00 Add to cart -
10-inch Off-Road Dexter Style Electric Backing Plate – Left
$145.00 Add to cart -
12-inch Off-Road Dexter Style Electric Backing Plate – Left
$175.00 Add to cart -
10-inch Electric Backing Plate Pair (AU)
$180.00 Add to cart
Reviews